Elnur Gabarron BRISS Instructions D'installation Et Guide D'utilisation page 14

OPERATING MODES
6- Cooler Button
Press the cool air button, the cool indicating light will be in and the unit starts to
pump up water and shower the water curtain. The humid and comfortable cool
wind comes out.
When there is no water in the water tank, the LED indicator will show red, and the
beeping sounded.
7-Mode/UV Button
By pressing the mode/UV button you can control which fans operate, both
together, upper only or lower only. The relevant lights illuminate to inform you of
your selection.
And the UV function will be on automatically when the fan starts to work and
sterilize the air quality.
NOTE:
1. Please fill in with water before using the Cool Air function. If the water is under
low level or without water, the Cool Air function will not be activated until the
water tank is refilled.
2. The unit can be used without water as a normal electric fan. Please keep the
"Cooler" button at off mode during the humid weather.
3. Place the ice cubes or ice pack into the water tank can lower the water tem-
perature and strengthen cool air function.