Publicité
ENGLISH
3. This wet/dry vac is equipped with a float
mechanism which will rise automatically to
cut off the airflow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank. You will know that
the float has shut the airflow off because the
suction ceases and the motor noise becomes
higher in pitch due to increased motor speed.
The liquid capacity may vary with the rate of
pickup.
Float in
raised position
IMPORTANT: To reduce the risk of damage to
the vac, do not run motor with float in raised
position.
NOTICE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND TURN
SWITCH OFF. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU
WILL BE ABLE TO CONTINUE OPERATION.
EMPTYING THE TANK
WARNING: To reduce the risk of injury
from accidental starting, unplug power cord
before emptying the dust tank.
1. Remove the power head assembly of the
wet/dry vac by pulling outward on the lid
clips located on each side of the vac. Lift
off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
3. Liquid waster may be emptied by removing
the tank drain. To empty, turn unit off and
remove plug from the wall. To empty, turn unit
off and remove plug from the wall receptacle.
Remove the drain cap and deposit the liquid
receptacle. Remove the drain cap and deposit the
liquid waste conents in a suitable drain. After tank
is emplty, return the drain cap to its original
position. To continue use, plug the cord into the
wall receptacle and turn the unit on.
BLOWING OPERATION
WARNING: Always wear safety eyewear
complying with ANSI Z87.1 (or in Canada CSA
Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders,
keep them clear of blowing debris.
CAUTION: Wear a dust mask if blowing
creates dust which might be inhaled.
CAUTION: To reduce the risk of hearing
loss, wear ear protectors when using the vac/blower
for extended hours or when using it in a noisy area.
The vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It
can be used to blow dust and debris out of garages
or off patios and driveways. Follow the steps below
to use the vac as a blower.
1. Locate blower port on the vacuum.
2. Insert one end of the 1-7/8 in. x 6 ft.
(4.8 cm x 1.8 m) hose into the blower port.
3. Turn the vacuum "ON".
6
Publicité
