Adjusting The Aiming Beam Brightness; Adjusting The Beeping Volume; Tip Initiation Instructions - SDC MLD-810 Manuel D'utilisation

Adjusting the Aiming Beam Brightness

1
Press the Menu/Selection button 3x.
The display shows Aiming Beam.
2
Press the Up and Down Arrow buttons to
scroll through your Aiming Beam options
(Low, Medium, High).
In this case the first option shown is High.
Continue to press the Up or Down Arrow
buttons to browse through the other options.
3
To make a selection, press the
Menu/Selection button again.

Adjusting the Beeping Volume

1
Press the Menu/Selection button 4x.
The display shows Beep Volume.
2
Press the Up and Down Arrow buttons
to scroll through your beeping volume
options (Low, Medium, High).
In this case the first option shown is High.
Continue to press the Up or Down Arrow
buttons to browse through the other options.
3
To make a selection, press the
Menu/Selection button again.

Tip Initiation Instructions

If the procedure requires an initiated tip, increase the laser output power to a value of
0.6 W by pressing the Up Arrow (
Touch a piece of carbon film with the end of the tip and depress the foot switch to
activate the laser.
When laser emission begins, move the tip back and forth over the surface of the
carbon film. You will observe a rapid melting/vaporization of the film and the tip
should become dark.
) button until 0.6 W is reached.
40