Publicité
UNPACKING AND INSPECTION
WARNING: DO NOT operate this product if damaged during shipment, handling or misuse.
Do not operate the product until the parts have been replaced or the fault rectified. Failure to do
so may result in serious personal injury or property damage. All damaged parts must be repaired
or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings
are secure before putting this product into service.
If you have any questions, or require assistance with damaged or missing parts, please contact
our customer service department at 1-800-497-0552. Please have the serial number, model
number, and date of purchase available for reference when calling.
SAFETY
• Be aware of what you are doing and use common sense while using the tool. Do not use a
tool when you are tired or under the influence of drugs, alcohol or medication. A moment of
distraction while using a tool can cause serious personal injury.
• Use safety equipment. Always wear eye protection. Safety equipment such as dust masks,
non-slip safety shoes, helmets or ear protection used in appropriate conditions will reduce
the risk of injury.
• Keep the tool away from children and do not allow tool to be used by people who are not
familiar with the operation of the tool. Tools are dangerous in the hands of inexperienced
operators.
• Never use a tool other than for its intended purpose.
• Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
• Do not misuse the cord. Do not use the cord for carrying, pulling or unplugging the tool.
Keep the cord away from heat, oil, edges or moving parts. Damaged or entangled cords
increase the risk of electric shock.
• Work in a well-ventilated area.
• When operating a tool outside, use an extension cord suitable for outdoor use. Using an
extension cord suitable for outdoor use reduces the risk of electric shock.
• Do not expose power tools to rain or wet conditions. The penetration of water into a tool
increases the risk of electric shock.
OPERATION
NOTE: This tool will not work on plastic or aluminum
surfaces.
NOTE: Do not use crafting glue sticks.
DENT REMOVAL PROCEDURE:
Adhering Pull Buttons
1. Insert Glue Stick (2) into Glue Gun (1). Plug in Glue
Gun and allow it to warm up for ten to fifteen
minutes before use.
2. Select the Plastic Pull Button (5) that best matches
the size and shape of the dent to be pulled.
3. Prepare the surface by cleaning it with mild soap
and water and allow it to dry completely.
4. Find and mark the center of the dent with a dry-
erase marker. Larger dents may benefit from
multiple pulls from different locations.
5. Apply glue to the Pull Button, quickly place it on the
center of the dent, and hold it there for ten seconds.
(Figure 1 & 2)
6. After applying wait several minutes for the glue to
solidify before applying the puller.
Figure 2
Figure 1
3
Publicité
