Samsung WF45K6500A Série Mode D'emploi page 21

STEP 3 Adjust the levelling feet
STEP 4 Connect the water hose
WF45K6500AV_DC68-03665A-02_EN.indd 21
1. Gently slide the washer into position.
Excessive force may damage the
levelling feet.
2. Level the washer by manually adjusting
the levelling feet.
3. When levelling is complete, tighten the
nuts using the spanner.
NOTE
An adjustable wrench or 17 mm open-
end wrench is required to loosen or
tighten the leveling feet.
CAUTION
• Make sure you use a new water hose,
and there are rubber gaskets (B) inside
the couplings (A) at either end of the
water hose. A water hose without the
gasket may leak.
• If there is a water leak, stop using the
washer and contact a local Samsung
service center. A water leak may cause
B
electric shock.
• Do not stretch the water hose by force.
If the hose is too short, replace the hose
with a longer, high-pressure hose.
A
• To prevent leaks, make sure both water
hoses are not bent or kinked. A water
leak may cause electric shock.
English 21
2016/8/12 14:37:45