Télécharger Imprimer la page

Steinberg Systems SBS-LAB-110 Manuel D'utilisation page 9

Controleur de pipette electromecanique

Publicité

2. Using the device
Application
This device is used for moving liquid from the original container to another container within a certain
volume range.
Device operating environment
For indoor use only
Altitude: 2000 m
The working temperature range of the device is +5°C~+40°C.
The applicable temperature range of the device is 80%.
Ensure that the area around the device is free from airflow or vibrations that could
impact its performance.
Usage
Gently push the suction tube into the silicone adapter, and carefully set it in place. For proper
insertion of suction tube, separately hold the mouth of the adapter tube and the upper end of the
suction tube.
By using the speed control button below the LCD screen, you can set the desired suction and
discharge speeds. The suction and discharge speeds have 6 steps and can be adjusted with the
speed control buttons marked with up and down arrows. The LCD display shows the selected
speed. In addition, gravity can also be used for draining liquids.
Select the appropriate speed, press the suction button, and draw the liquid slightly over the desired
volume. Remove the suction tube from the liquid in the container. Then press the liquid feeding
button to discharge part of the liquid, so that the bottom of the liquid in the suction tube reaches the
desired level.
Two different drainage modes:
Gravity drainage: touch the drainage button and press it slightly. Like this, the drainage function will
act under its own weight, and the liquid will be discharged naturally.
Electric drainage: pressing the discharge button further will trigger the micro pump to speed up the
discharge speed.
(Note: in either case, the discharge speed can be sensitively adjusted by finger pressure.)
Safety Precautions
Charge the device for 10 hours before its first use to ensure a sufficient power supply. For future
charges, the duration is 2-3 hours. Before plugging the AC charger into the power outlet, ensure that
the input voltage and connector type are compatible with local standards.
EN

Publicité

loading