Publicité
power, the yellow light will turn on, and the green light will turn off, allowing the electrothermal tube to
reheat. This cycle maintains the temperature within a controlled range.
NOTE
•
Pay close attention to the water level during operation to prevent overflow. Ensure the
electrothermal tube is never operated without water (dry burning is prohibited).
•
If any abnormalities occur during operation, stop using the device immediately and
perform troubleshooting before resuming use.
Maintenance
•
Before cleaning and maintenance, ensure the power supply is turned off to prevent accidents.
•
After daily use, wipe the surface and power cord with a damp cloth and a non-corrosive cleaner. Do
not use water directly to clean the machine, as this could damage its electrical components.
•
Regularly empty the oil collection box during cleaning to avoid overflow.
Troubleshooting
Phenomenon
Power is connected, but the
indicator light is off and the
griddle doesn't heat up.
Power indicator light is on, but
the griddle doesn't heat.
Power indicator light is on, but
the temperature setting doesn't
heat up.
Temperature controls function
normally, but the indicator light
doesn't turn on.
Transportation and Storage
•
Handle the products with care to avoid strong vibrations during transport.
•
Packed products should not be stored outdoors for extended periods. Instead, store them in a well-
ventilated warehouse free from corrosive gases. Ensure they are not placed upside down.
•
If temporary storage is necessary, make sure to implement proper rainproof measures.
Disposing of Used Devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with their markings. By choosing to recycle you are making a
significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Possible Reasons
1. Fuse in the master switch is
burned out.
2.
Power line is loose or not
connected properly.
1. Some electrothermal tube
connections are loose or
disconnected.
2. Electrothermal tube is
burned out.
1. Temperature controller is
burned out.
2. Contactors are burned out.
Indicator light is burned out or
has a loose connection.
Handling Methods
1. Replace the fuse.
2. Tighten the power line.
1. Check and tighten the
connections and screws of the
electrothermal tube.
2. Replace the electrothermal
tube.
1. Replace the temperature
controller.
2. Replace the contactors.
Replace the indicator light or
tighten the connection.
Publicité
