Publicité
EN
1
Wait at least 40 minutes until the shredder has cooled down. Observe the minimum clearance
to walls and the information on continuous operation in Technical Data.
Î After the cooling phase, the power LED lights up blue and shredding continues.
Overload Protection
If you have fed more material than specified in the technical data, a paper jam will occur.
1
Move the main switch to the REV position.
Î The material is briefly pushed back.
2
Pull the material out of the document shredder.
Î You have released the blockage.
After the material has been removed from the paper shredder, the cutting unit continues to
move for 3 seconds to clean itself. Wait until the paper shredder has come to a standstill again
and the power LED lights up blue.
Oiling the Cutting Mechanism
If you want to increase the working life of the shredder, you should oil the shredder's cutting
mechanism at regular intervals.
Special oil and oiled sheets are available for the shredder from HP.
Important!
Risk of property damage through using the wrong oil! Do not use spray oils. Only use a special oil
intended for shredders.
There are various ways to oil the cutting mechanism.
Oiling Using Self-Oiled Paper:
1
Apply the special oil for shredders in several lines horizontally across a sheet of paper.
2
Insert the oiled sheet of paper in the insertion slot.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Oiling Using Oiled Sheets
1
Insert the oiled sheet in the paper infeed.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Emptying the Waste Bin
Check the fill level of the waste bin through the viewing window at regular and when it is about
80% full, empty it. This prevents the shredded material from accumulating, which could lead to
malfunctions.
- 16 -
Publicité
