Publicité
block these off.
The electrical socket must be easily accessible so that
-
the power lead can be disconnected easily, in the case
of an emergency .
The device and power cord should not come in contact
-
with the hot surface. The device could be damaged.
The installation and assembly of this device in non-
-
stationary setup locations must be carried out by
specialist companies/ electricians, provided they
guarantee the prerequisites for the safe use of this
device.
Electrical connection
In order to ensure the safe and trouble-free operation of
the device, the following instructions
must be observed for the electrical connection:
• Before connecting the device, compare the connection
data (voltage and frequency) on the rating plate with
those of your electrical network. This data must agree
in order that no damages occur in the device. If in
doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety
cut-out switch, separate ly from other electricity
consumers.
• The connection between the device and the electrical
network
extension cable with a cross-section of 1.5 mm2. The
use of multiple plugs or gangs is prohibited because of
the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has
not been installed under the oven or over hot or sharp
surfaces.
may
employ
a
3-meter-long
(max.)
Publicité
