Publicité
GB
Multi-power
Power
Capacity
H. Max.
Outlet Ø
Cable length
Size
A
B
C
1000
2500
15 W
40 W
1000 l/h
2500 l/h
1.40 m
2.30 m
12 mm
12/16/20 mm
1.80 m
2.50 m
107x84x123 mm
135x105x152 mm
Function
Multi-purpose pump for water changes, water
circulation and draining aquariums, sumps and filters.
The inlet is located at the bottom of the pump, which
allows pumping until the water level is at 1 cm.
Installation
For use as a circulation pump, install the pump when
completely submersed under water.
3 cm
To be able to start the pump, when changing the
A
water or draining aquariums, sumps and filters, the
water level must be at least 3 cm. Switch off the
1 cm
pump when the water level is only 1 cm.
Connect a hose (not included) using the correct
diameter to the hose connection. The Multi-Power 2500
has 3 interchangeable hose connections (ø 12/16/20
mm).
Turn the pump on by plugging it into the mains.
Maintenance
The pump should be cleaned regularly (minimum twice
a year) to ensure trouble free operation. Scale deposits,
in particular, can cause your pump to cease. There is no
warranty on failures due to dirty pumps and scale build
up inside the pump caused by improper or lack of
maintenance.
Remove the plug from the socket before carrying
out maintenance!
Disconnect the pump from the hose and rinse the
housing under the tap.
For proper cleaning and descaling, it is best to use
SuperFish Pump & UVC Clean (Art. 07070500), which is
available from your dealer.
Remove the bottom of the pump by loosening the
B
Rotor
screws.
Now you can pull the rotor out of the pump.
C
Brush and clean the rotor, the bottom and the housing
thoroughly. Rinse everything with clean tap water and
reassemble.
Depending on usage the rotor can get worn out and
damaged, this is normal. A new rotor (MP 1000: Art.
A7031097, MP2500: Art. A7031099) is available from
your dealer.
Publicité
