Reservoir Assembly - Ars3000 - 12 Gallon - Nautilus DOL-FYN AR18 Guide D'utilisation Et D'entretien

RESERVOIR ASSEMBLY — ARS3000
1) Place the reservoir on the floor, open side down, so that the legs are standing
straight up.
2) Install the two caster support assemblies onto the reservoir legs by inserting
the raised steel tabs on the caster support assembly into the open end of
the legs. Securely fasten the caster support assemblies in place using the
four ¼" – 20 x ½" screws.
3) Install the four black plastic end caps by inserting an end cap into each open
end of the caster support assembly by hand and then tapping into place
using a mallet.
4) Install the four casters into the holes provided on the caster support assem-
bly. Tighten securely. Turn reservoir over so that it stands open side up.
5) Decide if you wish to mount the sight gauge faucet on either the wide or the
narrow face of the reservoir. Install the sight gauge faucet by placing one
rubber washer onto the threaded end of the faucet and inserting the faucet
through the mounting hole in the reservoir. From inside the reservoir securely
tighten in place using the black plastic jam nut. Inspect to make sure that the
sight gauge is straight. Position the sight gauge retaining ring over the sight
gauge and hook it over the edge of the reservoir.
6) Install the reservoir plug by putting a rubber washer over the threaded
end of the plug and inserting it into the remaining hole in the reservoir.
From inside the reservoir, tighten into place using a black plastic jam
nut. Do not over-tighten jam nuts. Avoid squeezing out rubber washer.
7) Install the prepared post carbon filter cup by following the instructions
on page 11.
Note: If installing an ARS2000 / ARS3000 Pump Box, please refer to the
Pump Box Use and Care Guide (included with your Pump Box) in order to complete
the assembly of the reservoir. The demand Pump Box is an optional addition to
your system.
- 12 gallon (45.4 liter)
9