Goobay 68856 Mode D'emploi page 11

2. PATCHPANELS / WALL PLATES / other CABLES:
all Models: Use the external receiver like described.
3. MEASURING:
Model 93010:
1. Connect a fitting cable to the device.
2. Switch on the device.
3. Select between AUTO- and User Manual-mode.
AUTO-mode tests all twisted pairs independently. Use the User Manual-mode to check
each pair separately.
Models 68856, 68857 and 68858:
1. Connect a fitting cable to the device.
2. Switch on the device.
3. The product shows all characteristics of the connected cable automatically.
Model 68856:
situation 1: Pin 2 is configured 1:1 - cable ok
situation 2: Pin 2 is not connected. - cable defect
situation 3: Pin 2 and 3 are short-circuited. - cable defect
situation 4: Pin 2 is connected to Pin 6 - crossover cable or defect
BNC TEST:
FUNCTIONS:
Model 68857:
S flashes on for correct connected screening
C/1-8 LEDs flash on for correct wiring
SHORT Short-circuit
CONNECTED pins connected 1:1 / BNC 25 Ohms
NON-PARALLEL interchanged leads / BNC 50 Ohms
NO CONNECTION cable defect / no termination
BATTERY GOOD battery full
BATTERY LOW battery empty
Model 68858:
POWER device is switched on
LOW BATTERY battery empty
CONNECTED pins connected 1:1
NO CONNECTION cable defect
SHORT Short-circuit
CROSS interchanged lead / crossover cable
Matrix LEDs of the specific cable types flash on.
BNC core
BNC screening
remove it
remove it
11