Resetting The Unit; Debugging Code - Teac Rc-L800 Manuel Du Propriétaire

Re-setting the Unit
The following operation will reset all settings to
the default settings.
1. Enter the setup mode.
2. Press 5 or b to select RESET and press
ENTER. A confirmation message appears.
3. If you wish to confirm reset, press ENTER to
reset all settings to the default settings.
< If not, press MENU to exit.
< is displayed when the unit has been
reset.
34

Debugging Code

DEBUG in the CODE menu in setup mode is used
only for servicing and not during normal use.