Télécharger Imprimer la page

Pettec Remote Vibra Advance 2.0 Mode D'emploi page 24

Publicité

How the remote control buttons work
Dog toggle switch (1 / 2)
1
Located on the upper left face of the remote control is a toggle switch, allowing
switch between Dog 1 and Dog 2.
Adjustment signal intensity
2
Intensity Up Button (
Intensity Down Button (
Sound only button (TONE)
3
Sends an audible tone to the trainer. No vibration is delivered.
4
Vibration only button (VIBRA)
Delivers vibration through the Contact Area on the remote control at the level shown
on the digital display. When held down for ten consecutive seconds, the trainer will
"time-out", and vibration cannot be delivered for five seconds. You must release
and press the button again after the five second time-out period, before additional
vibration can be delivered.
Vibration/sound signal button (DUAL)
5
Pressing this key transmits both a vibration and a sound signal at the same time.
PetTec-Tipp:
To connect a second trainer, please set the toggle switch to 2 and switch on the trainer to
be connected. The new trainer connects to the remote control by simultaneously pressing
the tone signal and vibration buttons. Read more on page 32.
24
): Increases vibration or sound intensity by 1.
): Decreases vibration or intensity by 1.

Publicité

loading