Technical Data; Assembly; Operation; Adjusting The Feed-In Brushes - HERKULES H-RM 700 Mode D'emploi D'origine

Anleitung_H_KM_700_SPK7:_

5. Technical data

Working width
Debris collector
Sweeping capacity (at 4 km/h)
Size
Weight
6. Assembly (Fig. 2-6)
Note: You will find the feed-in brushes and the
assembly material in the debris collector.
1. The feed-in brushes (8) are fastened to the
locating plates with 3 screws (9) each.
2. Insert the push bar mounts (4a/4b) into the
receiving slots.
3. Secure the push bar mounts (4a/4b) with the
screws (6).
4. Push the bottom section of the push bar (2) onto
the push bar mounts (4a/4b) and secure with the
two adjustment nuts (5).
5. Slide the top section of the push bar (1) onto the
bottom section of the push bar (2) and secure
with two assembly screws (7) and two adjustment
nuts (5).
7. Operation (Fig. 7)
When the mechanical sweeper is pushed, the feed-in
brushes (B) and the pick-up brushes (C) are set in
rotation by the belt drives (A). The rotating feed-in
brushes (B) sweep the dirt to the center. The two
counter-rotating pick-up brushes (C) convey the dirt
into the debris collector (Fig. 1/6).

8. Adjusting the feed-in brushes

(Fig. 8)
The feed-in brushes can be adjusted infinitely as
required (5).

9. Emptying the debris collector

(Fig. 9)
After sweeping up metal, glass or sharp objects, wear
heavy-duty work gloves when emptying the debris
collector.
01.04.2011 12:55 Uhr
10. Height adjustment and folding of
the push bar (Fig. 10/11)
70 cm
Remove the adjustment nuts (2) and the relevant
20 l
screws. Select one of the three holes (F) as required,
max. 2800 m 2 /h
then re-tighten the adjustment nuts (2) and the
relevant screws. The push bar can be set to three
650 x 600 x 210 mm
different heights over a range of approximately
8.9 kg
98 cm - 94 cm - 89 cm. The push bar can be folded
as shown in Fig. 11.

11. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Seite 11
GB
11