Hansgrohe Focus E 04365 0 Série Instructions De Montage / Mode D'emploi / Garantie page 10

7
2
1
5
6
2
10
3 mm
27 mm
1
English
Install the spout escutcheon.
Press the spout over the spout tee. Install and
tighten the set screw with a 3 mm Allen wrench.
Do not overtighten the set screw
or the o-rings on the sealing ring
will deform, which will cause a
leak.
Turn on the water and check all connections for
leaks.
04366xx0 only:
Remove the brass plug from the tee.
Lightly lubricate the diverter o-rings using white
grease (not included).
Press the diverter assembly firmly into the spout
tee until it is fully seated.
Turn the guide bushing so that the slot faces the
rear of the spout.