MHZ PowerView Rollo Mode D'emploi page 25

Roller Blind Programming Guide
PowerView® I
All manuals and user guides at all-guides.com
Set end positions (set top end position for 18 V)
+
+
+
Press Motor button and keep
pressed.
Additionally, within 3 seconds,
briefly press Open button .
Release Motor button.
Using the Move buttons, move
the blind into the desired
position.
Press Stop button for 6 seconds.
(Do not select a channel button
on the remote control unit)
Press Motor button and keep
pressed.
Additionally, within 3 seconds,
briefly press Open button .
Release Motor button.
If the buttons are still flashing,
the remote control unit is still in
'Teach-in Readiness' mode.
Press Stop button for 6 seconds
or wait for 20 seconds.
The top end position has now
been set.
EN
Blind briefly moves once
up and down.
Button lighting on the
trans mitter flashes.
Teach-in readiness
established.
Blind briefly moves up and
down once.
Button lighting on the
trans mitter stops flashing.
Teach-in readiness ended.
To set again, repeat steps.
25