2. After cleaning for 1 minute, the indicator light will automatically switch to the dry
ironing state, and the dry ironing indicator light
seconds of delay, the product will be heated to dry the residual water in the soleplate.
Note: when the dry hot or steam indicator light is always on, Press and hold the steam
button A (7) for 5 seconds, and you can enter the cleaning function from any state of dry
ironing or steam. If dry hot or steam indicator light flashing, can not enter the cleaning
state.
Cleaning and maintenance
matters needing attention
Strong volatile solvent cleaning is prohibited
Do not put chemicals into the water tank
●Discharge the water in the water tank, put it back to the host, and place the product on
the base and on the stable table
●Do not wash the product in water or other solutions.
●Do not put vinegar, detergent, saline solution and other chemicals into the water tank.
Maintenance procedures
●If it is not applicable for a long time, please pull out the power supply.
●After each use, please drain the water in the water tank and return the water tank to
the main engine.
●Before cleaning or maintenance, be sure to remove the plug from the power supply
and allow the appliance to cool sufficiently (at least 30 minutes).
●Wipe the surface of the body with a dry towel to remove dust.
●Do not pour vinegar, detergent or other aromatic substances into the water tank.
Safeguard
●Temperature detection and protection
There is a temperature sensing element built into the appliance. When the temperature
rises abnormally, the temperature sensing element will output a signal to control the
disconnection of the heating element, so as to control the product temperature within
the appropriate temperature range.
●Thermal fuse protection
There is a thermal fuse inside the appliance. When the temperature is abnormal and the
temperature sensing element fails again, the thermal fuse will be disconnected to cut off
the power supply directly to prevent accidents.
EN
will flash into the delay state. After 40
7