Cleaning And Maintenance - Alpina 871125218737 Manuel D'utilisation

CLEANING AND MAINTENANCE

Make sure the appliance is disconnected from the power supply before
cleaning it.
For blender
An 'auto clean' cycle can be used to clean the blender easily and rapidly in
complete safety.
1. Pour a little warm soapy water into the jar, turn the speed control to the '1'
setting, then select the pulse setting for a few seconds without releasing
the control.
2. Remove all detachable parts. Remove the jar from the motor unit and rinse
it under running water, then detach the blade assembly from the jar
assembly, take the blade assembly out and finally remove the jar base seal
ring . Also, detach the measuring cup from the jar cover. Rinse the jar,
blade, jar base, jar cover and measuring cup under running water.
3. Wipe the outer surface of the motor unit with a damp cloth.
NOTE: Do not use abrasive cleanser and never immerse the motor unit
in water to clean it.
4. Dry all parts, then reassemble them. The blender parts are reassembled in
the opposite order to disassembly.
NOTE: If any problem has been encountered during use,
never disassemble the motor unit yourself. There are no
user-serviceable parts inside. Only contact the authorised
service facility for examination and repair.
6