TREVIDEA G3FERRARI WIND MASTRO Manuel De L'utilisateur page 10

- Do not subject the product to strong impacts, serious
damages may result.
Do not connect the electric plug since the installation is
not complete. Do not leave the appliance unattended
while it is running. Unplug after each use.
Unplug unit by pulling the plug and not the power cord.
Do not immerse product in water or other liquids and
avoid splashing liquids reach the unit.
Place on solid and stable surfaces and away from
windows or drafts. Before carrying out any cleaning,
disconnect the unit from the electrical outlet.
Before each use, unroll the power cord. Do not insert
anything through the protection grids.
Do not obstruct in any way the protection grids.
DESCRIPTION G50051
1 Air outlet
5 Air grids
9 Button Light
OPERATING
Connect the plug to the electrical outlet. The display (2) switch on and show ambient temperature.
The control panel (3) and the remote control operate the various functions of the fan.
Press button ON/OFF (11). The fan switches on.
Press the button SPEED (8) to adjust the wind power different speeds.
1: low speed
OSCILLATION
pressing the button oscillation (7). Push again to disable the oscillation.
TIMER
The fan is equipped with a 12 hours timer. Press button TIMER (10) if you want the appliance to
turn off after a certain period of time (between 1 and 12 hours). Press once to set it off after 1 hour, twice to
set 2 hours, and so on up to 12 hours. The display indicates the time set for the timer.
NATURAL MODE
Pressing one time the button MODE (12) the fan enters in NATURAL mode and the corresponding light
switches on. In this mode the fan reproduces the natural breath of the wind, according to some preset cycles.
REMOTE CONTROL
type AAA following the correct polarity (+/-). Close the battery cover before using the remote control.
- Remove the batteries if you will not use the remote for an extended period of time.
- Whatever the type of exhausted battery, it must not be thrown in the household waste, in the fire or in the
GENERAL INFORMATION
2 Fan
6 Base
10 Button Timer
2: medium speed
The oscillation is only possible when the fan is turned on and it can be activated by
Open the cover on the back of the remote control and insert 2 batteries 1.5V
3 Display
7 Button Oscillation
11 Button ON/OFF
3: high speed
4 Motor housing
8 Button Speed
12 Button Mode
9