Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Screen operation
Connection of the radio frequency remote control
The radio remote control is already paired at the factory with the integrated
receiver. If the link is interrupted, please follow the procedure below:
1. Press the "Up" key for 3 seconds until the LED on the remote control lights
up, then plug in the display power cord. A beep confirms that pairing has
been started.
2. Release the "Up" button when you hear the beep sound.
3. Briefly press the "Up" button and release it. When the beep sounds 3 times
quickly, the remote control pairing is complete.
Connecting the infrared remote control
Connect the IR receiver to the external IR connector and position the receiver so
that there is permanent visual contact between the remote control and the
receiver.
Trigger
With the Trigger, the screen can open and close automatically when you turn the
projector on and off. To do this, connect the screen to the Trigger port of your
projector via the Trigger cable.
Your projector connection may need to be enabled through software for the
projector to send control signals to the screen. For more information, refer to
your device's user manual or contact the projector manufacturer.
Trigger input port voltage: DC / AC 5V - DC / AC 20V
7
Publicité
Table des Matières
