Wall Mounting - Cisco 300 Série Guide De Démarrage Rapide

Rack-Mount Placement
Remove the four screws from each side near the front of the switch.
S 1
TEP
Retain the screws for re-installation. (Do not remove the four screws
from each side near the back of the switch.)
Place one of the supplied spacers on the side of the switch so the
S 2
TEP
four holes of the spacers align to the screw holes. Place a rack
mount bracket next to the spacer and reinstall the four screws
removed in
If your screws are not long enough to reattach the bracket
N
OTE
with the spacer in place, attach the bracket directly to the case
without the spacer.
Repeat
S 3
TEP
After the mounting hardware has been securely attached, the
S 4
TEP
switch is now ready to be installed into a standard 19-inch rack.
For stability, load the rack from the bottom to the top, with the
C
AUTION
heaviest devices on the bottom. A top-heavy rack is likely to
be unstable and may tip over.

Wall Mounting

Only the 8-port models of the switch can be wall-mounted.
The switch should be mounted so that the ports face up or down.
N
OTE
Do not mount the switch with the ports to the side.
4
Step 1.
Step 2 for the other side of the switch.
Cisco 300 Series Managed Switches