Shure SBC200 Mode D'emploi page 7

SBC200 Charger
The SBC200 two-bay charger holds two SBC900 batteries,
transmitters, or bodypacks. It may be used in any appropriate
location with adequate space and ventilation.
Features
• Charge up to two SB900 batteries, body packs or transmitters
• Connect up to four units using one PS45 Power supply
• LED icons for battery status
• Works with compatible hand held and bodypack units such as
the P9RA, P10R, ULXD1, and ULXD2
Included Components
• SBC200 Charger
• PS45 Power Supply (not included with SBC200 model
variation)
• Screws for attaching additional units (8)
• Allen Wrench (hex key)
SB900 batteries not included.
All manuals and user guides at all-guides.com
Note:
• This equipment is intended to be used in professional audio
• EMC conformance is based on the use of supplied and
• Use this battery charger only with the Shure charging
• Changes or modifications not expressly approved by Shure
• Battery packs may explode or release toxic materials. Risk
• Follow instructions from manufacturer
• Never put batteries in mouth. If swallowed, contact your
• Do not short circuit; may cause burns or catch fire
• Do not charge or use battery packs with other than specified
• Dispose of battery packs properly. Check with local vendor
• Batteries (battery pack or batteries installed) shall not be
applications.
recommended cable types. The use of other cable types
may degrade EMC performance.
modules and battery packs for which it is designed. Use with
other than the specified modules and battery packs may
increase the risk of fire or explosion.
Incorporated could void your authority to operate this
equipment.
WARNING
of fire or burns. Do not open, crush, modify, disassemble,
heat above 140°F (60°C), or incinerate
physician or local poison control center
Shure products
for proper disposal of used battery packs
exposed to excessive heat such as sunshine, fire or the like
WARNING: Danger of explosion if battery incorrectly
replaced. Operate only with Shure compatible
batteries.
1