CGV HEL PRELUDE 2 Guide D'utilisation Rapide page 7

6. Turn the headphone on
Once the headphone has been fully charged, do not forget to turn it ON
manually before using it. Once ON, the headphone will automatically enter
in connection with the docking station after a few seconds (up to 1min.).
Three audible beep sounds must be heard.
Note:
for pairing to work properly, it is important that the headphone be kept within 10 meters of the
docking station all along the pairing operation
7. Pair the headphone with the docking station
- If the headphone doesn't pair with the default station
- To add a second headphone on the same station
If the (POWER) LED on the docking station is permanently slowly flashing ORANGE (one flash
each 6 seconds), then perform the following steps:
7.1 Connect the docking station to the main through its power adaptor.
7.2 Press the button "POWER"
→ Check that the headphone light turns on in fixed blue color.
7.3 Press the "MUTE"
→ Check that the headphone light blinks in blue and generates quick beeps.
7.4 Press the button at the bottom of the docking station for 3 to 4 seconds
→ Check that the POWER/CHARGE light on the front of the docking station
flashes green.
7.5 The LEDs will stop blinking after a few seconds.
→ Check that the headphone light is fixed blue, the light
and that you can hear the sound in the headphone if select a valid audio source. ➔ The pairing
procedure is successfully complete. Otherwise, restart the procedure form the beginning.
.
of the headphone for ~3 seconds to turn it on.
button of the headphone for 3 seconds.
of the docking station is fixed green