Care & Maintenance - Wagan Tech Wet & Dry Ultra Vac 750 Guide D'utilisation

Wet & Dry Ultra Vac
WARNINGS
• This vacuum cleaner operates from 12 volt sockets only and is designed for use with the 12
volt cigarette lighter socket in your car.
• You must ensure that all other electrical equipment in the car are switched off when vacuum
is in use.
USAGE
Vacuuming Instructions
1. Select the attachment you wish to use and connect it to one end of the hose.
2. Connect the other end of the hose to the Vacuum Port.
3. Plug the DC cord into your DC socket.
4. Locate the power switch on the motor housing underneath the casing handle and turn the
unit on. (Tip: It is a good idea to leave your car running while operating this unit to avoid
draining your battery.)
5. When finished, turn the unit off using the same power switch then unplug the DC cord from
the DC socket.
6. Clean out dirt, debris, and etc from the reservoir by unlatching the three clips in the same
manner as described in "Parts & Accessories".
7. Return vacuum parts back into the canister for storing.
Inflating Instructions
1. Connect the Inflator Adapter to one end of the hose.
2. Connect the other end of the hose to the Inflator Port.
3. Follow steps #3-7 from the "Vacuuming Instructions".
CARE & MAINTENANCE
1. DO NOT submerge vacuum in water.
2. After using the Wet & Dry Ultra Vac to vacuum up liquid, make sure to clean the reservoir
and filter. Let all parts dry fully before storing it away for future use.
5
by Wagan Tech
™
www.wagan.com
®