Kichler Compass Manuel D'instructions page 13

INSTALLING THE LIGHT KIT AND ACRYLIC SHADE
NOTE: NOTE: Before continuing installation, confirm that the power is still turned off Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the circuit fuse. Turning the power at the main circuit breaker or by removing the circuit fuse. Turning the power
Light Plate Assembly
off using a wall switch is not sufficient to prevent electrical stock. off using a wall switch is not sufficient to prevent electrical stock.
Screw
Step 1. Step 1. Remove three screws on the light plate assembly and keep for later Remove three screws on the light plate assembly and keep for later
Fig. 21
use. (Fig. 21) use. (Fig. 21)
Step 2. Step 2. Hold the light kit close to the light plate assembly and connect the Hold the light kit close to the light plate assembly and connect the
9-Pin Connector
9-pin connector together. Note: The two connectors have keyholes that 9-pin connector together. Note: The two connectors have keyholes that
must be mated correctly before they can be engaged. (Fig. 22) must be mated correctly before they can be engaged. (Fig. 22)
Step 3. Step 3. Tuck the connections neatly into light kit, then attach the light kit to Tuck the connections neatly into light kit, then attach the light kit to
Light Kit
light plate assembly and securely tighten with three screws removed on step light plate assembly and securely tighten with three screws removed on step
Fig. 22
1.(Fig. 23) 1.(Fig. 23)
Step 4 Step 4. Secure the acrylic shade to light plate assembly by twisting in a . Secure the acrylic shade to light plate assembly by twisting in a
clockwise direction, twist the acrylic shade gradually until it snaps on to the clockwise direction, twist the acrylic shade gradually until it snaps on to the
light plate assembly. Do not over - tighten. (Fig. 23) light plate assembly. Do not over - tighten. (Fig. 23)
Light Plate Assembly
Acrylic Shade
Fig. 23
52" Compass LED | 13