Troubleshooting Guide - Craftsman CMECS600 Guide D'utilisation

English
exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
90 DAY MOnEY BACK gUARAnTEE
If you are not completely satisfied with the performance of
your CRAFTSMAN Power Tool or Nailer for any reason, you
can return it within 90 days from the date of purchase with a
receipt for a full refund – no questions asked.
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1-888-331-4569
for a free replacement.
For assistance with your product, visit our website at www.craftsman.com for a list of service centers, or call CRAFTSMAN
at 1-888-331-4569.
PROBlEM
Unit will not start.
Bar / chain overheated.
Chain is loose.
Poor cut quality.
Unit runs but does not cut.
12

TROUBLESHOOTING GUIDE

BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
POssiBlE CAUsE
Cord not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is not working.
Lock-off button not actuated.
Chain too tight.
Lubrication needed.
Chain tension set incorrectly.
Chain tension set incorrectly.
Chain needs to be sharpened.
Chain needs replacement.
Chain installed backwards.
sOlUTiOn
Plug chain saw into a working outlet.
Remplacer le fusible du circuit. (Si le est grillé. Roduit fait griller
de façon répétée le fusible du circuit, arrêter immédiatement
d'utiliser lcommuniquer avec l'assistance Craftsman au
888-331-4569
Reset circuit breaker. (If the product repeatedly causes the
circuit breaker to trip, discontinue use immediately and call the
CRAFTSMAN help line at 888-331-4569.
Call the CRAFTSMAN help line at 888-331-4569 to have cord or
switch replaced.
Push lock off button and then depress the trigger switch.
Refer to section on Adjusting Chain Tension.
Refer to Saw Chain and Guide Bar Oiling.
Refer to Adjusting Chain Tension.
Refer to Adjusting Chain Tension. NOTE: Excessive tension
leads to excessive wear and reduction in life of bar & chain.
Lubricate after every 10 minutes of use. Refer to section for
installation of chain.
Refer to Saw Chain Sharpening.
Refer to Replacing the Saw Chain.
Refer to Installing the Guide Bar and Saw Chain.