IFM Electronic E30062 Notice De Montage page 3

1 2
1
Slip the conduit adapter (7) onto the connection
cable.
3
Slip the clamping device onto the connection
cable. Screw the coupling (A) of the conduit
adapter into the clamping device.
5
Put the clamp fastener (1) around the sensor, slip
the clamping device onto it, screw the nuts
slightly onto it.
Align the adapter and tighten the nuts evenly
(max. tightening torque 5 Nm /3.5 Lbf.ft).
3 4 5 6
A
7
2
Remove the protective foil from the seal (4).
Glue the seal onto the clamping device (5).
4
Screw the connection cable onto the sensor
plug.
clamp fastener
1
sensor
2
connection cable
3
seal
4
clamping device
5
nuts
6
conduit adapter
7
with ½"-14 NP coupling