PEERLESS Mounts SmartMount SA740P Installation Et Montage page 10

Cables may also be secured to slot at bottom of wall plate using a cable tie (P) as shown below.
5-3
Tension Adjustment
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the screen
to fall.
• If screws become loose over time, tighten screws as necessary. Tighten screws to 50 in. • lb (5.6 N.M.) maximum
torque.
If more or less tension is desired in the arm pivot points, do the following:
6
• To increase tension, turn tension screw(s) clockwise using 5 mm allen wrenchs (U). NOTE: Tighten screws to
50 in. • lb (5.6 N.M.) maximum torque.
• To reduce tension, turn tension screw(s) couter-clockwise using 5 mm allen wrenchs (U). NOTE: Do not loosen
more than half a turn.
All manuals and user guides at all-guides.com
WARNING
TENSION SCREWS
A
10 of 42
All other brand and product names are trademarks or registered trademarks of their respective owners.
SLOT
P
CABLES
ISSUED: 07-12-06 SHEET #: 095-9234-12 11-20-09
TENSION SCREWS
© 2009, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
3215 W. North Ave.
Melrose Park, IL 60160
www.peerlessmounts.com