MHZ PowerView Surface Kit Notice Abrégée page 22

Venetian blinds Programming Guide
PowerView® I
All manuals and user guides at all-guides.com
Set end positions (set top/bottom end position)
2
1
22
Top end position
Press Stop button for 6 seconds.
Button lighting on the transmitter flashes.
Teach-in readiness established.
Do not select a channel button on the remote control unit.
Press Motor button and keep pressed.
Additionally , within 3
1
seconds, briefly press
Open button
.
Blind briefly moves up and down once.
Release Motor button.
If the buttons are still flashing, the remote controlunit is still in
'Teach-in Readiness' mode: Press Stop button for 6 seconds or
wait for 20 seconds.
Button lighting on the transmitter stops flashing.
Teach-in readiness ended.
The desired top/bottom end position has now been set.
To set again, repeat steps.
Bottom end position
Additionally , within 3
2
seconds, briefly press
Close button
.