Coleman QUICKPUMP 5999E300C Mode D'emploi

QUICKPUM P
5999E300C
• Inflates AND deflates
• Adaptor works with Coleman ® Double Lock™ Valve as well
as other airbed valves on the market
• Operates on four D-cell batteries
• Airbed pump only
• Always purchase the correct size and grade of battery most
suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to
battery installation.
• Ensure the batteries are installed correctly with regard to
polarity (+ and –).
• Remove batteries from equipment which is not to be used for
an extended period of time.
• Remove used batteries promptly.
Please call or write us with any comments or questions:
The Coleman Company, Inc.
3600 N. Hydraulic • Wichita, KS 67219 U.S.A.
1 800 835-3278 • TDD: 316 832-8707
www.coleman.com
Manufactured in China
All manuals and user guides at all-guides.com
4D BATTERY
™
INFLATING COLEMAN ® DOUBLE LOCK™ VALVE:
To begin inflation, open external cap and
pull firmly on lanyard to extend out. This
will open internal yellow seal.
Attach adapter nozzle to inflation end of
pump. Insert pump and turn on.
When fully inflated, seal valve by pushing
in with pump nozzle. This will seal the
internal yellow stopper and keep air from
escaping while closing cap.
Fully remove pump and close
external cap. Valve should
appear depressed into itself.
DEFLATION
Remove adapter nozzle from inflation end
and attach to deflation side of pump. Repeat
same steps as inflation. This will draw the
air out quickly.
OTHER VALVES:
WORKS WITH STANDARD WIDE OPENING AND BOSTON STYLE VALVES.
Note: For optimum performance, alkaline batteries are recommended.
Coleman ® , , and , are registered trademarks and QuickPump
Double Lock TM are trademarks of The Coleman Company, Inc.
TM and
4010004406 (20081023)