Comment Remplacer Le Tube En Alu - Maxx 777.400.100 Mode D'emploi

Comment remplacer le tube en alu

Operating instructions:
1. Remove loose dirt from the surface you wish to clean (brush or vacuum clean).
2. Connect the MAXX to a compressor. Check the condition of the couplings and
hose before using the MAXX Cleaning Gun.
3. Turn the black rocker lever into the vertical position to activate the (cleaning)
liquid in the bottle.
4. Important: Hold the cleaning spout at a distance of 3 cm from the surface you are
cleaning.
5. Press the "trigger" all the way; move the Maxx slowly in circular motions over the
surface you are cleaning.
6. Turn the black rocker lever into the horizontal "air only" position, press the
trigger and dry the surface you have cleaned.
7. To remove any remaining moisture, wipe the cleaned surface with a dry cloth.
8. Clean the spout as follows: Turn the black rocker lever to the horizontal "air only"
position, hold the cleaning nozzle in a bucket and press the trigger all the way in
order to remove any soiling from the nozzle.
CARE AND MAINTENANCE
Clean the Maxx after each usage as described in point 8.
Every day spray a small amount of lubricant in the nozzle outlet and also in the air
inlet.
REQUIRED AIR RATE
To perform to its full potential, the Maxx requires a constant air pressure of 8 bar.
CAUTION: Constant air rates vary depending on the size and power of the
compressor. Always make sure that the tank and the air hoses are free from
impurities of any kind.
6 27