Cleaning And Maintenance; Storage - Tippmann TMC Série Manuel D'utilisation

Cleaning and Maintenance

• To reduce the chance of an accidental discharge, follow the
(on page 10) and
Marker
• Eye protection must be worn.
• Do not disassemble a marker while it is pressurized with air.
• Do not pressurize a partially assembled marker.
• Follow warnings listed on the air/CO2 cylinder for handling and storage.
• Familiarize yourself with instructions listed on air/CO2 cylinder.
• Contact the air/CO2 cylinder manufacturer with any questions.
• Do not use any petroleum based cleaning solvents.
• Do not use any cleaning solvents that come in aerosol cans.
: Petroleum based products and aerosol products can damage your marker's
NOTE
O-Rings.
To clean the exterior of your marker, use a damp towel to wipe off paint, grease, and any
debris.
Hopper Fed
To clean inside the barrel, remove the Feed Tube. Unscrew the Locking Cap from the
Feed Tube. Rotate the Feed Tube out to remove it from the marker. Insert the squeegee
into the breech. Pull squeegee through the barrel to remove paint or debris.
Magazine Fed
To clean inside the barrel, remove the Magazine. Insert the squeegee into the breech
going through the Magazine well. Pull squeegee through the barrel to remove paint or
debris.
Alternative Barrel Cleaning method:
You can also remove the barrel to pull the squeegee through it.

Storage

Ensure the Safety Selector Switch is in Safe mode (see page 6), and the barrel blocking
device is installed (see page 5). Always unload your marker (page 10) and remove the air
supply (page 12) when not using your marker. Store your marker in a dry area.
When removing your marker out of storage, make sure to keep the Safety Selector Switch in
Safe mode (see page 6) and keep the barrel blocking device installed (see page 5).
TMC 50 Caliber Owner's Manual | Rev. 1 May 2018
Air/CO2 Cylinder Removal
Unloading Your
(on page 12).
E
N
G
L
I
S
H
13