Quasimidi SIRIUS Manuel D'utilisation page 83

Chorus: The chorus doubles up the original signal and then sends the double back with a minimum time-delay,
making it sort of 'swirl'. This makes the sound wider, fuller and 'fatter'.
SlowChor: The Slow-Chorus works the same way as the chorus.
FastChor: The delay in the Fast-Chorus is so intense that you will have a very strong swirling effect.
SuperChr: The Super chorus creates a strong swirling and phasing. The sound appears large and extremely
warm.
FeedbChr: The Feedback-Chorus is a special effect influencing the sound in a dramatic way. The
feedback to the input is so strong that you will get an almost metallic sound. This gives the sound a
completely new character, almost robotic.
The Effects
Flanger: This effect allows you to create very spacy sounds. The flanger is based on the same
principle as the chorus but creates a stronger modulation. The flanger will sound particularly
interesting on the Hihat-track. Check it out with bass sounds too!!
These 'modulation' effects have the following parameters available:
Apart from the modulation effects already mentioned, FX2 also has 2 Echo-effects available.
ShortDel: This delay creates a very short echo.
PanDelay: This delay is like the PanDelay from section FX1.
The FX 2 echo-effects have the following parameters available:
Level(0-127): Here the level sent into the effect can be set. The higher the level the more the
original sound is influenced, ie. the greater the amount of chorusing or flange on the sound.
Time (0-127): Here you can set the time delay of the Chorused signal in relation to the
Original signal.
Feedback (0-127): The parameter Feedback routes back the effects signal to the effects
input in controllable increments. This creates feedback causing a drastic sound change.
Rate (0-127): Here you can set the rate or speed of the modulation.
Depth (0-127): This parameter allows you to set the depth of the modulation.
Level (0-127): Here the level sent into the effect can be set. The higher the level the more
the original sound is influenced, ie. the greater the amount of echo on the sound.
Time (0-127): Here you can set the delay time of the echo. The lower the value the faster the
echo comes back. The maximum delay for these two effects is 870 ms (milliseconds).
Feedback (0-127): This value allows you to set the number of echoes.
83