Daan Tech Bob. Guide Rapide page 5

2 | S -
ET UP AND
2.1 | Water inlet
1
Plug the water inlet hose
on one side to the back of Bob and on the other
side to a water inlet via a 19 mm threaded end
(3/4 inch) and make sure the connection is
fi rmly tightened.
WARNING: Close the water supply tap
after each use of Bob.
Warning: Do not block the water inlet of
the water tank. This must always remain
free.
2.2 | Water outlet
Plug the water drain hose to the back of Bob.
Warning: To prevent leaks, please use a screwdriver to fi x the
water outlet.
C
ONNECTIONS
2 available options
Using Bob as an autonomous free-standing
dishwasher thanks to its built-in water tank. In
this case, no water inlet hose is needed! Please
use Bob Carafe to quickly fi ll the water tank! Bob
can be fi lled with either cold or hot water up to
60°C.
Please always fi ll the water tank before use (4L
capacity) with the door open, until you hear the
signal sound that indicates that the tank is full.
2
Do not overfi ll the tank! If you fi ll in
more than the water tank capacity (4 L),
the excess water will escape into Bob's
main interior.
3