DURAVIT Light and Mirror LM 7820 L/R Notice De Montage page 6

1
2
1
> Remove the mirror
fronts of the cabinet by
unlatching each hinge.
5
Ø ⅜"
> Use a 3/8" drill bit.
> Drill the anchor holes that
have been marked.
2
> Remove the mirror fronts.
6
4x S8
> The plastic anchors
provided are for concrete
wall applications.
3
4 9
14 23
10 23
Two types of installation:
> Surface-mount which
simply means hanging
the cabinet on the wall.
Pictures 4-9 and 14-23.
> Recessed which requires
cutting into the wall.
Pictures 10-23.
7
4x 5,5x50
> Screw the bracket(s) to
the wall at the specified
location.
> For wood stud walls, bolts
should be screwed into
wood backing.
4
110 V
NOTICE
A 110 V GFCI outlet is
required.
> Mark the holes to be
drilled for the anchors.
8
N
N
G G
L
L
> Note the location of the
hardwire box on the back
of the cabinet. Provide
a cutout in the wall to
accommodate the depth
of this box as well as the
electrical conduit entering
the box. Please reference
hardwire instructions pg. 9.
NOTICE
A length of conduit must be
provided from the wall cutout
long enough to reach the floor.
> Lift the unit up and onto the
mounting bracket.
> Lay the bottom of the
mirror against the wall and
tighten the set screw to
secure the mirror in place.
MAL_Light and Mirror_LM 7820 L/R/19.10.3
6