Lubrication; Storage; Service - Shop-Vac Ch87-600C Manuel D'utilisation

No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
1. Before storing your vacuum the tank should be emptied and cleaned. Never allow liquids to sit in the tank
for any extended period of time.
2. The power cord can be wrapped around the cord wraps provided on the top of the
tank cover located in front and behind the handle.
3. To remove the cord from the cord wraps grasp the sides of the rear cord wrap located
behind the handle, turn counter clockwise 180° until the tip of the cord wrap is above
the handle.
4. Grasp the entire cord behind the handle and pull above the rear cord wrap, pull cord
towards the front of the vac until the cord becomes disconnected from the front cord
wrap.
5. Grasp the sides of the rear cord wrap and turn clockwise 180° to return it to its original
position. The vacuum should be stored indoors.
Do not attempt to service your Shop-Vac
Refer all other servicing to a qualified service center.

LUBRICATION

STORAGE

SERVICE

wet/dry vacuum cleaner beyond that described in this manual.
®
PAGE 9