identités 861207 Notice D'instructions page 14

Please make sure that the ear is clean, with no earwax or obstructions.
The right ear reading may differ from the reading taken at the left ear.
Therefore, always take the temperature in the same ear.
Children aged 1 year to adult: Pull the ear up and back.
Do not force the thermometer into the ear canal. Otherwise, the ear canal may get injured.
When taking the temperature on an adult, gently pull the ear up and back to make sure the ear canal is straight, so
that the temperature probe can receive an infrared ray from the eardrum.
Be careful when taking temperature on a child, whose ear canal is small.
3. Take room/object temperature
When the thermometer is power off, press the Memory/Mute-unmute button for 3 seconds until it shows
. Then press the Measure button to measure. Keep the thermometer about 1-5 cm away from the object.
Press and release the Measure button in 1 second, the beep is heard, you can read the value.
4. After a measurement
Once the reading has been completed, remove the thermometer away from the forehead/ear and observe temperature.
After each measurement, you can enter the recall mode and query earlier temperature readings.
Do not hold the thermometer for a long time, because it is sensitive to the ambient temperature.
After each measurement, clean the temperature probe with a soft cloth, and put the thermometer in a dry and
well-ventilated place.
You should wait at least 10 seconds between each measurement.
It is dangerous to make a self-diagnosis or self-treatment based on the obtained measurement results. For
such purposes, please consult a doctor.
5. Read your temperature
T indicates a temperature reading. In forehead or ear mode.
1. If 32°C≦T≦37.3°C(89.6°F≦T≦99.2°F), the green light will last for 3 seconds, with one long beep.
2. If 37.4°C≦T≦37.9°C(99.3°F≦T≦100.3°F), the orange light will last for 3 seconds, with 3 short beeps, and the value in
LCD flickers, which is a warning that you may have a light fever.
3. If 38°C≦T≦42.9°C(100.4°F≦T≦109.2°F), the red light will last for 3 seconds, with 5 short beeps, and the value in LCD
flickers, which is a warning that you may have a high fever.
6. Switching between mute and un-mute
When the thermometer is turned on, keep pressing the Memory/Mute-unmute button for 2-3 seconds, to
switch from un-mute to mute.
7. Checking 35 sets of memory data
When the thermometer is turned on or power off, by pressing the Memory/Mute-unmute button to go to the memory mode,
press this button again to check the 35 sets of memories one by one. If no value, it will display "---M".
8. ºC/ºF conversion
Open the battery cover, user the toggle switch to change the ºC/ºF.
NOT-AD - 70 Novembre 2020 (Version 1.0) 14