Power On/Off - Ozobot Evo & Bit 2.0 Guide Rapide

English

Power On/Off

Press and quickly release Ozobot's power button
to turn on. Press and quickly release the power
button again to turn off.
Calibrate on paper
Calibrate the Ozobot before each use, or when it
changes surface or environment. Sign a completely
black dot of approximately 2.5 cm holds the
Ozobot for 2 seconds and sets it on the dot.
Ozobot drives slightly forward and blinks green.
Start flashing again with red.
Digital calibration
For calibration on digital screens, go to the
Ozobot app> Tune up screen and follow the
steps described in Calibrate on paper.
Charging Ozobot
Charge Ozobot with the included USB cable
as soon as the robot starts flashing red. When
the Ozobot gives green light, it is fully charged.
Clean your Ozobot
Attention! Do not clean with water and / or soap. In
take a clean white sheet of paper instead. Move
now Ozobot's wheels on the paper and drive softly
and back on the paper. The wheels are clean again.
12