Tripp-Lite SmartRack SRCOOL7KDUCT Manuel Du Propriétaire page 3

Installation
Before proceeding to install the SRCOOL7KDUCT, first make sure the air conditioning unit is correctly installed per the
instructions shown in the SRCOOL7KRM Owner's Manual.
1 Fasten the Manifold Assembly to rear of SRCOOL7KRM using the
four (4) included M4 screws.
2 Attach the Short Flexible Tube to the Manifold Assembly by
turning the tube's threaded end into the manifold's adapter.
3 Attach the Short Flexible Tube to the Tube Adapter by turning the
adapter onto the tube's threaded side.
4 Attach the Tube Adapter to the inside of the perforated rack
enclosure door .
A
Note: The Tube Adapter uses internal magnets to attach to the rack
enclosure.
1
2
3
4
3
A