Nautilus W10120N Guide D'utilisation Et D'entretien page 9

securing nut, with baffle properly in place,
onto the boiling chamber before each use.
Failure to properly secure the baffle and nut
may result in leakage or early shut off of the
distiller.
7. Wipe off any water on the outside and bottom
of the boiling chamber and around the elec-
trical connection.
8. Slide the boiling chamber into the distiller
chassis and press firmly to ensure that it is
properly placed. It is important that the boiling
chamber be pressed firmly into the distiller
chassis. It is recommended that you place one
hand on the back of the distiller chassis and
push the boiling chamber into the chassis with
the other hand. To ensure that a tight electrical
connection is made, also press on the base of
the boiling chamber near the start button.
CAUTION: To prevent personal injury or
property damage the boiling chamber
must be fully en gaged prior to start-up.
9. Press the "start" button at the base of the
boiling chamber.
NOTE: The button will glow when the
boiling chamber is heating; however, the
light will go out, and the boiling chamber will stop
heating if elec tri cal power to the boiling chamber is
interrupted or stopped. If this occurs, press the start
button again to restart the distillation cycle.
10. The cooling fan will not start immediately.
A delayed fan startup feature has been included
in your distiller. The fan will start once the boiling
chamber has reached a pre-determined tempera-
ture, approx imately 30-40 minutes after starting
the cycle.
11. Place a prepared carbon filter (see page 4) into the
opening at the top of the water bottle. Do not
install cap onto water bottle. The bottle must
be left un capped to allow water to enter it from
the distiller.
Spout
-6-
O-Ring
Flat Gasket
Flat edge
Baffle
of baffle
Securing
Filter
Dispensing Valve
Nut