Safety Instructions - Hauff-Technik HRD 200-SG-3/6-54-4/6-26 Instructions De Montage

Standard-Press seal HRD-SG
Contents
1 General information and intended use

2 Safety instructions

3 Description
4 Scope of delivery
5 Required tools and aids
6 Installation
1 General information and intended use
HRD-SG standard press seals are suitable for the installation and insertion of 1 to 15 cables/pipes with outer
diameter 3.5 to 110 mm in core drills/wall sleeves with inner diameter 80 to 200 mm.
2 Safety instructions
Protect the Standard-Press seal HRD-SG from damage, moisture and impurities during installation.
Check that all necessary components have been delivered and that they are not damaged. You
must not install damaged components.
Standard-Press seal HRD-SG installation must comply with the relevant professional association
regulations, VDE provisions, national safety and accident prevention regulations as well as
company regulations (work and procedural instructions).
Do not use solvent-based cleaning agents to clean the Standard-Press seal HRD-SG! We recom-
mend using Hauff-Technik KR60 cable cleaner.
Standard-Press seal HRD-SG are not fixed points or bearings and therefore cannot absorb any
mechanical forces. Any anticipated reductions must be compensated for by the installation of
centering guides and/or spacers in the conduits or core drillings.
3 Description (e.g.: HRD 200-SG- 3/6-54-4/6-26)
Segment ring
Blank seal
Cut surface
Press-seal nut
Press plates
made of
stainless steel
8
GB