Initial Steps - LA VAGUE LV-HD240 Mode D'emploi

INITIAL STEPS

1. Connecting the power cable
Connect the power cable to the side of the projector and to a power outlet. If the indicator
light at the top of the projector turns red, the projector is in standby mode
2. Power up
Remove the lens cap from the lens.
Press the „Power" button on the top of the projector or the „Power" button on the remote
control. If the indicator light at the top of the projector is solid green, the projector is turned
on. To turn off the projector, press the „Power" button again - either on the projector or on
the remote control.
3. Image Settings
To raise or lower the front of the
projector, turn the adjustable foot
located on the bottom of the projector.
Use the front adjustment wheel, also
located on the top of the projector, to
adjust the image focus. Use the rear
keystone adjustment wheel, located at
the top of the projector, to adjust the
angle of the projector.
18