KS Tools 150.4316 Notice D'utilisation page 5

Assembly and use
1. Charging
Connect the charger into charging socket (7), which is located on the rear of work light.
Connect the 230V charger (9) or 12/24V (8) charger to a power supply.
The charging indicator will illuminate to show the charging has started.
NOTE: The charging indicator (4) will turn green when the lamp is fully charged.
Disconnect the charger from the work light when it has been charged for a sufficient time.
2. Operating the lamp
CAUTION : Never shine the LED light directly in the eyes .
Function : 100%-50%-Flash-SOS-OFF. Press the button (3) to switch from a function to another.
The lamp can be attached to ferrous metal by use of the magnets.