Publicité
This manual describes the installation and operation of the Comfort Glow, WMPS7000, 4840 wood heater. This
heater meets the 2020 U.S. Environmental protection agency's crib wood emission limits for wood heaters sold after
may 15, 2020. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 8,141 to
12,161 btu/hr output.
Heating Specifications
Heating Capacity
Fuel Burn Rate
Burn Time (lowest setting)
Hopper Capacity *
Electrical Specifications
Electrical Rating
Watts (operational)
Watts (igniter running)
Dimensions
Height X Width X Depth
Depth with Mounting Wall Bracket Approx. 14.27" [362.4 mm]
Bottom Of Unit To Exhaust Pipe
Center
IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT
WITH THE OPERATING INSTRUCTIONS IN THE OWNER'S MANUAL.
500 - 1,000 sq. ft.
* Pellet size may affect the actual rate of fuel feed, burn
3/4 - 2 1/2 lbs./hr.
times, and hopper capacity. Fuel feed rates may vary by as
35 hours
much as 20%. Use PFI listed fuel for best results.
*up to 28 lbs
110-120 volt, 60Hz, 3.0 Amp
175 approximately
425 approximately
27" [685.7 mm] X 36" [914.4 mm] X 12.43" [315.77 mm]
16.02" (407 mm)
WARNING:
2
INTRODUCTION
Publicité
