Connecting The Control Unit - Imetec SCALDALETTO N3920 Instructions D'utilisation

• Make sure the underblanket is always spread out smoothly and that there are no
creases.
• Make the bed, laying the mattress cover and/or the first sheet on top of the underblanket.
Place the second sheet and the normal blanket or duvet on top.

CONNECTING THE CONTROL UNIT

• Insert the control unit connector (2) in the underblanket connector (1) to connect the
control unit to the underblanket.
• For the double bed model, repeat the operation for the second control unit as well.
• Run the control unit cable along the floor next to the bed. Do not squash the control
unit cable between the mattress and the bed frame.
• Insert the plug of the control unit cable in the mains socket (3).
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
The control unit can be set to the following temperature levels:
: temperature to pre-heat the bed
1-5: temperatures for night-time or continuous use
• Switch on your mattress cover from the back of the control unit (12), by positioning the
switch ON 'I'. The temperature setting (6) will default to the last one used.
• Press the Express fast pre-heat button on the front of the control unit (9) to pre-heat the bed.
The led will light up in red on the control unit (6).
• When the temperature reaches the proper level, press again the Express pre-heat button
(9) to deactivate the fast pre-heat function.
IMPORTANT: The time needed for the underblanket to warm up will depend on the
room temperature. The temperature of the underblanket must be evaluated by lying
in the bed rather than just feeling it by hand.
NIGHT-TIME OR CONTINUOUS USE
For night-time or continuous use of the appliance, set the
control unit to temperature levels from 1 to 5 only.
DO NOT get into bed with the control unit set to a higher
temperature than recommended for continuous use.
If the appliance is slept on with the controls set to a higher
temperature the user may suffer skin burns or heat stroke.
WARNING!
or under the sheets when in use.
DO NOT place the control unit under the pillow
EN
16