Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TECHNICAL SPECIFICATIONS
Frequency response:
20 Hz ~ 20 kHz
Audio sampling frequency:
192 kHz
Distortion:
1 KHz <0.001%
Supply voltage range:
9 V – 15 V
Signal to noise ratio:
> 120 dB
Dynamic range:
> 100 dB
Standby current:
< 0.4 mA
Dimensions (LxWxH):
105(126) x 114 x 40 mm
MAIN FEATURES
5-channel Smart Digital Preamplifi er with iOS or Android App controlled audio DSP
n
functions
DSP-controlled 5-channel Preout (10 Volt) including REM out to control optional
n
amplifi ers
Plug'N'Play quick installation system via optional vehicle brand and model specifi c
n
ISO wire harness
Auto-Turn-On function
n
4-channel RCA-Input and separate ACC/REM/Batt/GND socket for standalone
n
operation
FUNCTIONALITY & ADJUSTABILITY
Bluetooth connection and control of DSP settings via iOS or Android Smartphone App
n
Freely confi gurable 3-way active crossover: High-/Low-/Band-/Bypass with
n
6/12/18/24dB/Oct. slope
Time Alignment in cm (0 – 230 cm) for front, rear and subwoofer channel
n
5-channel control: Gain, Phase switch and Mute function for each speaker
n
Freely confi gurable 7-band parametric Equalizer for front, rear and all 4 speakers
n
Can save 5 memories in the amp and unlimited sound settings on the smartphone
n
Dynamic Bass setting for powerful performance without subwoofer
n
3D surround sound
n
DIMENSIONS
105 mm
– 4 –
INSTALLATION DIAGRAM
MOUNTING INSTRUCTIONS
1. Before you start with the installation, make sure you know the security code of your
headunit (if applicable).
2. Remove the headunit from the dashboard and disconnect the main wire.
3. Find a place for the A500DSP and connect the provided (or optionally available
car-specifi c) wire to the amp.
4. For standalone powering mode please follow these steps: Run a 1.5 mm
wire from the (+) pole of the battery to the (BATT) terminal of the amplifi er. Use a fuse
with the related value of the cross section of the power wire. The distance between
the B+ pole and the fuse holder must be 15 cm or less. Run the minus cable with the
same cross section from the (GND) terminal of the amp to the vehicle chassis ground.
Make sure that the contact surface is clean in order to get best conductance.
5. Connet the RCA cables and the ACC+/REM wire coming from the headunit to the
RCA inputs and ACC-In of the A500DSP.
6. Connect the wire to the headunit.
7. Install the headunit back in the dashboard.
ORIGINAL CAR SOCKETS
HEAD UNIT
power
2
– 5 –
Publicité
Table des Matières
