VARO POWERPLUS POWDP35100 Mode D'emploi page 47

NOTE: When you use the right angle grinder for cutting purposes, avoid
tilting it in the cutting plane. The cutting wheel must have a clean cutting
edge. A diamond cutting wheel is advised to cut hard stone.
WARNING: Never use a grinding disc for cutting.
WARNING: Never use a cutting wheel for rough grinding.
WARNING: Materials containing asbestos must not be processed!
12 CLEANING AND MAINTENANCE
12.1 Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
13 TECHNICAL DETAILS
Model nr.
Rotation speed
Disc diameter
Rated voltage
Spindle lock
Battery connection
Spindle thread
Soft grip
Safety guard
Soft start
14 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Copyright © 2024 VARO
POWDP35100
POWDP35100
8500 min-1
115 mm
20 V
Yes
Slide-on
M14
Yes
Yes
Yes
84 dB(A)
95 dB(A)
Max. 4.3 m/s²
P a g e | 11
K = 1.5 m/s²
www.varo.com
EN