cecotec BOLERO FLUX DT 608010 GLASS BLACK A++ Manuel D'instructions page 29

Masquer les pouces

page de 77

/ 77
Signets

Les langues disponibles

ENGLISH

Cleaning the filters

Do not use corrosive detergents to clean grease from the mesh filters. Regular cleaning of

the filters will prolong the life of the appliance and keep it in good working order. Follow the

instructions below:

Cleaning method 1: immerse the mesh filters in hot water (40-50 °C), add neutral

detergent and let them soak for 2 to 3 minutes. Protect yourself with gloves and clean the

filters with a soft brush or scouring pad. Do not apply too much force, as filters are very

delicate and can be easily damaged.

Cleaning method 2: if you wish, you can also wash the filters in the dishwasher at a

temperature of approx. 60 °C.

To remove the filter, press on the tabs as shown in Figure 10 and pull it out.

Carbon filter

This type of filter has activated carbon and purifies air and absorbs cooking odours. The

activated carbon becomes saturated after a period of time, which will reduce the adsorption

capacity of the filter. The carbon filter cannot be washed nor cleaned in any way. When its

service life comes to an end you must replace it with a new one.

It is recommended to check the condition of carbon filters regularly, at least two or three

times a year. Its replacement will depend on how the kitchen hood is used, as well as the

daily operating time.

In case of very frequent frying, shorten the time interval for checking and/or replacing the

carbon filters.

Installing the carbon filters

Remove the protective metal filters.

The carbon filters are located on both sides of the motor. Insert and turn the filters, until

they are firmly in place.

To replace the carbon filters, proceed in reverse order.

Carbon filters must not be exposed to heat.

Figure 11:

A: Closed

B: Opened

C: Opened

D: Closed

Carbon filter size > Φ176 x 35 mm

BOLERO FLUX DT 608010 GLASS BLACK A++/WHITE A++

BOLERO FLUX DT 908010 GLASS BLACK A++/WHITE A++

Replacing the light bulb/lamp

Please note:

The light bulb must be replaced by the official Cecotec Technical Support Service or

similarly qualified technicians.

Always disconnect the power supply before performing any operation on the appliance.

When handling the bulb, make sure that it has cooled down completely before any direct

contact with your hands.

When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming

into contact with the bulb, as this may reduce the bulb life.

Note:

Before changing the light bulb, make sure that the appliance is switched off and

unplugged.

Protect yourself from danger when changing the light bulb, e.g. by wearing gloves.

6. TROUBLESHOOTING

Fault

Cause

The kitchen hood is

The indicator light

obstructed.

is on, but the motor

The condenser is damaged.

does not work

Motor is jammed or bearing

damaged.

Motor is burnt or gives off a

bad smell.

In addition to the above, check the following:

Neither the light bulb

The light bulb has blown.

nor the motor work

Power cable is loose.

ENGLISH

Solution

Remove what is obstructing the hood.