Publicité
Maintenance prompt function
The treadmill have been Pre-lubricated before leave factory, it is not necessary to add lubricant oil when the
treadmill running first time. In order to keep the treadmill operating at its best condition, the treadmill is
equipped with oil adding reminding. When the treadmill running to 9000KM, LED will show "LUBRICATE", it
means need to add oil to the treadmill. After the first time oiling, the next reminding will display every
1000KM. Press "ENTER" to add oil and exit the reminding. Press "CLEAR" key to ignore lubricate
temporarily, LED will show "LUBRICATE" after 50KMS.
The LED will show "REPLACE BELT" when the treadmill running every 25000KM totally, press "ENTER" to
replace belt and exit the reminding, Press "CLEAR" to ignore replace belt temporarily, LED will show
"REPLACE BELT" after 50KMS
Shown as below:
Oil adding reminding
Mulfunction and treatment
Error code
01H
02H
04H
08H
10H
18H
replaces belt reminding
Description
Abnormal in
1.
temperature
sensor
is loose
Overcurrent
1. Power off for 5 minute then on, and start
2. Check whether the load is overweight
3.
4.
Overvoltage
1. Check whether the power supply voltage is normal
2. Power off for 1 minute then on, and start
3.
Overload
the system of self-protection activates, restart the treadmill
rotate, the load is too heavy, the current is too large, the system of
self-protection activates, adjust the treadmill to restart operation or
add the lubricating oil
motor is running, replace the motor
Default phase
U fault in current
sensor
Treatment countermeasures
Power off for 1 minute then on, and start
2.
Check whether the NTC plug connection on the converter
3.
If not, please contact customer service for support
Check whether the running belt needs lubricant, or the belt is
seriously worn, or the transmission mechanism (eg.roller) is
abnormal
If not, please contact customer service for support
If not, please contact customer service for support
1.The possible cause is that the current exceeds the rated load,
2.A part of the treadmill is stuck, resulting in the motor can not
3.
Check whether there is a flow sound or burning odor when the
4. Replace the controller
1.Check whether the input voltage is normal
2.Check whether the connector of the power socket plug is loose
1.
Check whether the converter connector is loose
2.If not, please contact customer service for support
Publicité
